How Single-Use Temperature Loggers Protect Cherry Shipments at Sea

Fresh cherries are one of the most temperature-sensitive products in global trade. In a typical season, containers leaving South America spend three to four weeks at sea before reaching Asian markets, and the fruit must be held at near-zero temperatures the entire way. A single cooling failure — even one that lasts only a few hours — can soften fruit, trigger decay on arrival, and turn a profitable container into a claim. 

 

The hidden gap: air temperature is not fruit temperature

Most reefer containers record the temperature of the air circulating through the unit. But the temperature that decides fruit quality is the pulp temperature inside the boxes, deep inside the pallet stack. When an importer rejects a container, the carrier's data may look perfect while the fruit tells a different story — and without independent records inside the load, the exporter has very little to show. 

A practical setup with single-use loggers

This is where single-use USB temperature and humidity loggers such as the ULogs4 Temp&RH Data Logger with LCD have become standard practice among exporters:

  • Placement: one logger per pallet, inserted at the warmest expected position in the stack, so the records reflect what the fruit actually experienced.
  • Start delay: using the free PC software, recording can be delayed by up to 30 days — useful when containers are stuffed days before the vessel sails, so the recording period matches the voyage rather than the warehouse.
  • Alarm limits: upper and lower temperature limits are configured before departure; any excursion is visible on the logger's LCD the moment the container is opened.
  • Evidence at destination: at the port, each logger is plugged into a computer and the complete trip report is exported and shared, giving every pallet its own temperature and humidity record.

Because the loggers are single-use and pre-calibrated, there is no recovery logistics and no calibration scheduling — the used unit travels out with the shipment and the fresh one goes in for the next load. 

What this changes for the exporter

The shift is from arguing about a container to showing data per pallet. When a quality question arises on arrival, both sides look at the same record: when the excursion happened, how long it lasted, and how many pallets were affected. In many cases this narrows the conversation from "the whole load is bad" to "these specific pallets were exposed" — which is also what insurance documentation requires.

For exporters shipping many containers per season, the per-pallet cost of a single-use logger is minor compared with the value of the fruit it documents. 

Products used in this scenario

  • ULogs4 Temp&RH Data Logger with LCD — single-use, USB report export
  • Free PC software — start delay up to 30 days, alarm configuration, report export

Send Us Your Inquiry

We will contact you as soon as possible

%{tishi_zhanwei}%